Design

    Low Power ADCs with four interleaved MSPS: Description and Design

    Description By interleaving Renesas' low power, high sample rate ADCs, it is possible to achieve a combination of ultra-high sample rate and very high dynamic...

    How to Configure the Tracking and Power Sequencing of FPGAs

    Introduction The increase of voltage input rails for delivering point-of-load power to DSPs, ASICs, FPGAs and microprocessors is creating more challenges for power supply designers....

    High Voltage Phase-Locked Loop (PLL) Synthesizer: Description and Design

    Circuit Function & Benefits The high performance PLL synthesizer circuit in Figure 1 requires 28 V for the tuning voltage of an octave range (1...

    Analysis of a Hall-Effect System with two Linear Sensor ICs for 30 mm Displacement

    A classic Hall sensing system uses a single sensor in front of a magnet, but linear measurement of the magnetic field is limited to...

    New Amplifier features Low Noise Rail-to-Rail Performance While Consuming Only 2.5mA

    The new LT 6202 op amp combines 100MHz gainbandwidth, 1.9nV/√Hz voltage noise and rail-to-rail inputs and outputs, while consuming only 2.5mA. It also features...

    Efficiency, Isolated Bidirectional DC-DC Converter Reference Design for UPS

    1  Description The TIDA-00951 design provides a reference solution for a 2-kW isolated bidirectional DC-DC converter capable of power transfer between a 400-V DC...

    Working of a Cost-Effective In-Vehicle Infotainment System

    Description This automotive reference design is based on TI’s Jacinto DRA71x processor and focuses on system level cost savings. The six-layer design reduces PCB costs...

    Boost, Single-Output, DC-DC Converter: Working & Design Specification

    Introduction The MAX1606 is a step-up DC-DC converter that contains a 0.5A internal power switch and a 0.5A output isolation switch in an 8-pin µMAX...

    Server Efficiency could be improved with Advanced Control Electronics

    Power-management methods and three-phase BLDCs for cooling reduce data-center energy use. This note discusses emerging energy-conservation strategies and examines some of the Allegro products...

    Reference Design for Various LED Ring Lighting Patterns

    Description This reference design enables human-machine interface scenarios with an LED ring that utilizes two LP5024 LED drivers to create vivid lighting patterns. Design helps...

    Understanding Electromigration and IR Drop in Semiconductor Chip Design: Challenges and Techniques

    Abstract As we push through lower technology nodes in the IC and chip design, the wire width goes thinner along with transistor size. This makes...

    How to make Small Asset Tracker Last Longer

    New, low-power data connections are sparking a proliferation of asset tracking solutions, thanks to their low cost of deployment. The effects can be seen...

    Bi-directional dual-active-bridge CLLLC resonant converter reference design

    Description The PMP21495 reference design is a 6.6 kW bi-directional dual-active-bridge resonant converter reference design that allows 380 VDC to 600 VDC input and...

    Comparing shunt and hall-based isolated current-sensing solutions in HEV/EV

    Introduction The global market for electric vehicles (EVs) and hybrid electric vehicles (HEVs) is rapidly growing as these vehicles offer higher fuel-efficiency and lower emissions...

    How embedded systems are protected by Physically Unclonable Function Technology

    Abstract Hardware-based security provides robust protection against cyberattacks, and physically unclonable function (PUF) technology can further enhance that level of protection when used by chips...

    Related News